Firefly Open Source Community

   Login   |   Register   |
New_Topic
12
New Topic

Windows 10 and Fireduino

42

Credits

0

Prestige

0

Contribution

new registration

Rank: 1

Credits
42
Posted at 2/7/2017 18:38:33     
How to update the firmware ? The manual says changed Blink - where can I get it ?
There is only a normal Blink , not changed find !
Reply

Use props Report

42

Credits

0

Prestige

0

Contribution

new registration

Rank: 1

Credits
42
Posted at 2/7/2017 18:40:11     
Last edited by keemal In 2/7/2017 19:02 Editor

Reply

Use props Report

37

Credits

0

Prestige

0

Contribution

new registration

Rank: 1

Credits
37
Posted at 5/12/2017 22:17:02     
Hello everyone :-)

I have also a problem to install Fireduino on windows 10.

I'm using a MacbookPro 2015 15inch with bootcamp (Windows 10 Pro N)

1) When I connect the Fireduino (it goes on since I can see the little blu and green blinks)
But I'm not able to see it on the device manager.
Like there : http://wiki.t-firefly.com/index. ... driver_installation
There is no Other devices / Unknown device

Even with the driver signature enforcement trick, I can't see the Fireduino.

Maybe I missed soemthing, or maybe there is a way to install the driver manually by putting the files at the right place ?

2) Also on the Arduino IDE link on this link : http://wiki.t-firefly.com/index.php/Fireduino/Install_IDE/en

I don't see any "Additional Boards Managers URLs...

Thanks for your attention.
cheers.
Reply

Use props Report

37

Credits

0

Prestige

0

Contribution

new registration

Rank: 1

Credits
37
Posted at 6/9/2017 00:30:10     
Last edited by satolas In 7/7/2017 02:37 Editor

Don't get the "Fireduino USB to serial port device driver installation" step.
I can just see my device as Rocksub.

I forgot to write about the last post, but I got it to work yeah :-)
Still have the last step "Fireduino USB to serial port device driver installation" that doesn't install but the fireduino seems to work anyways.

It was really idiot, I just don't really understood what was the step 1. and 2.
So basically... Don't forget to do that :
1. Press the UPGRADE key and hold.
2. Short press the RESET button,the PC finds unknown equipment

The UPGRADE bottom is next to the card reader and the RESET button next to the AC input.
Of course don't forget to enable test mode via the windows command prompt by typing "bcdedit /set testsigning on".
Restart, and you should see on your desktop a little white text on the corner down right
"Test Mode
Windows 10 Pro N
Build ......"

And then follow the steps of the link :http://wiki.t-firefly.com/index.php/Fireduino/Install_Driver/en#Development_board_driver_installation...
For the "Fireduino USB to serial port device driver installation" if you have a solution tell me :-)

Regards
satolas
Reply

Use props Report

Return to List
12
You need to log in before you can reply Login | Register

This forum Credits Rules

Quick Reply Back to top Back to list