A little confused

penguin

The heatsink installing direction, paying attention to the holes with red circle:

penguin

I was able to burn the Ubuntu 18.04 image on a micro SSD. I attached and configured the debug card. I followed the instructions for flashing the board. I have no idea if it worked or not. There were not any light indicators. I even tried plugging in the board. Nothing lights up. I cannot find anything in the manual about indicators. Is there any?

There's a yellow LED on the bottom right of the board which is lit when entering into OS.

There is a slot for a battery on the board, but nothing to indicate the type and size.

The model of the battery is CR1220 .

The directions say to solder the EMMC, but it came with mounting screws and the only place where it could be mounted, is where the NCSS board is mounted.

The eMMC module and the NCSS board share the same extension interface. No soldering is required or possible I'm afraid.

penguin

Hi @hsedidin

Usually, there's an INI file containing the UI language configuration, quoting from the doc:

1. Locate the file named config.ini, and edit it by changing the 4th line from Selected=1 to Selected=2, in order to select English as the default user interface language.
   

Copy the code

penguin

Hi @mj07, what problem did you come across?