Firefly Open Source Community

   Login   |   Register   |
New_Topic

Unable to run built Linux images

14

Credits

0

Prestige

0

Contribution

new registration

Rank: 1

Credits
14
Posted at 9/9/2020 02:14:37     
I just got my ROC-RK3328-CC board.  Trying to build a Linux image for it using instructions at this link:

http://wiki.t-firefly.com/ROC-RK3328-CC/linux_compile.html

After following all steps, flashed the image on SD card using the following command:

sudo dd if=rockdev/pack/ROC-RK3328-CC-BUILDROOT-GPT-20200908-1351.img of=/dev/sdc  conv=notrunc

But, the image doesn't boot.  I don't have the serial port connection working yet, but I don't see anything from the HDMI port that's connected to a monitor.  I also tried the Ubuntu build and that image doesn't boot either.  I am able to flash the prebuilt image from http://share.loverpi.com/board/l ... 28-cc/image/ubuntu/ and that comes up fine.  But, the images that I build don't seem to do anything.  Any suggestions?  
Reply

Use props Report

14

Credits

0

Prestige

0

Contribution

new registration

Rank: 1

Credits
14
Posted at 9/9/2020 03:13:15     
Just want to add that it appears that .img files that are created during the build don't seem to be in correct format.  The pre-built image that I downloaded, I am able to open with 7-zip as an archive, but I am unable to do that with the images that I built.
Reply

Use props Report

You need to log in before you can reply Login | Register

This forum Credits Rules

Quick Reply Back to top Back to list