Title: RK3399 bricked after connecting M.2 [Print This Page] Author: cdslashetc Time: 4/1/2017 09:31 Title: RK3399 bricked after connecting M.2 I have a Mac so have to use Windows VM then connect the USB to the VM. After booting with M.2 SSD, the blue light no longer comes on and I can't get the board into recovery mode even after removing M.2. I can get into MaskRom mode by shorting the jumper as shown, but shows "Download failed" when I try to flash.
I'm hoping these more detailed instructions for MarsBoard will provide some clues--NOT the jumper though that is different--but explains how to flash only certain partition by check/uncheck boxes on the first tab. It may be necessary to press what they call "Restore" button after entering Maskrom (Recovery?) then may be able to flash it.
Would be interested to know if there is a way to boot from SD or other device instead of NAND or to flash via serial.Author: isle Time: 4/6/2017 10:48
Hi ,did you try to flash the whole firmware but not the only certain partition with the MaskRom mode?Author: peterev394 Time: 1/26/2026 14:34
Thank you for bringing this shocking article! The 300-725 frenquent update platform offers comprehensive content for free, aimed at helping you.Author: philbel997 Time: 2/20/2026 05:58
This article is a great source of inspiration, thank you! The CIS-Discovery latest exam answers questions were key to my promotion and salary increase, and today I'm sharing them for free!
Welcome Firefly Open Source Community (https://bbs.t-firefly.com/)