Title: Error -110 whilst initializing SD card [Print This Page] Author: Scottcjordan Time: 7/2/2018 05:00 Title: Error -110 whilst initializing SD card Just received my Renegade board. Nice little piece of kit but I can¡¯t say I¡¯m impressed with the online instructions and resources. The preferred SD flashing utility is, contrary to what¡¯s stated, available for Windows only. Etcher works fine on my Mac but the downloaded disk image is not recognized. Adding an ¡°.img¡± extension allows Etcher to proceed but who knows if that is the right thing to do. In any case, I get a consistent Error -110 during the boot process and then the thing hangs. This has occurred with a fresh SanDisk 32Gb SD card, a known-good 32Gb card from a Raspberry Pi, and a second known-good 8Gb card from a Raspberry Pi.
So I¡¯m stuck. Any suggestions?
Welcome Firefly Open Source Community (https://bbs.t-firefly.com/)