Title: Firefly-PX3-SE SDK permission denied [Print This Page] Author: daema218 Time: 7/5/2018 12:22 Title: Firefly-PX3-SE SDK permission denied Hi.
I recently purchased a Firefly-PX3-SE borad.
During the tutorial, I see the following message.
[dhkim@esvdev(10:24:14) ~/work/firefly] git pull gitlab firefly-px3se:firefly-px3se
Permission denied (publickey).
fatal: Could not read from remote repository.
Please make sure you have the correct access rights
and the repository exists.
How do I get permission?
Thanks!Author: Livvol Time: 7/5/2018 14:30
Hi,
Sign up for a GitLab account£Ĵand add SSH keys to your GitLab account.Author: Livvol Time: 7/6/2018 16:20
A more convenient way is to update the remote address by running this :
$ git remote set-url gitlab https://gitlab.com/TeeFirefly/px3se-buildroot.gitAuthor: daema218 Time: 7/11/2018 09:42
Thanks your advice.
I solved the problem.Author: kurksai Time: 12/12/2025 06:34
Hi all. I was in a terrible spot. I needed to save for a new 4K monitor for my design work. I tried my luck online, hoping for a miracle, but I just kept losing. It was the worst timing, and the stress was unbearable. I felt completely stuck. I saw a mention of spino gambino and thought, "one final attempt." I risked a bit more than I usually would. After a few tense minutes, it hit a huge win. I was just staring at the screen in disbelief. That win covered the entire cost of the monitor. It was such a massive relief. .
Welcome Firefly Open Source Community (https://bbs.t-firefly.com/)