Firefly Open Source Community

Title: Charging the ROC - RK3399 - MEZZ - M2 - POE [Print This Page]

Author: gjames@smu.ca Time: 3/8/2019 21:27
Title: Charging the ROC - RK3399 - MEZZ - M2 - POE
I dug out my old RC iMax b6 lipo charger to try and charge the battery.
It can balance charge a 2 cell lipo.
On the charger there is a 3 pin balance charging socket which measures and controls the charging.
On the ROC - RK3399 - MEZZ - M2 - POE there is a 3 pin port marked BAT2+ BAT1+ BAT1-.
Do I connect my chargers balance charging socket to the 3 pin port on the POE board?

This is the only document I can find on the battery:
ROC - RK3399 - MEZZ - M2 - POE
3) Onboard battery (dual 7.4V lithium battery)
4) Onboard balanced charging circuit to charge the onboard battery

Thank You

Author: penguin Time: 3/12/2019 09:20
Do you want to charge the battery or want to power the board?

Author: penguin Time: 3/12/2019 09:45
The 3 pins socket (bat2+,bat1+,bat-) only be connected to the battery,not the charger

IMG_20190311_180623.jpg (119.9 KB, Down times: 598)

IMG_20190311_180633.jpg (139.03 KB, Down times: 604)

QQͼƬ20190312092604.jpg (152.17 KB, Down times: 604)

Author: gjames@smu.ca Time: 3/24/2019 18:27
So as long as it is 7.4v battery it will work? Will C discharge 25c be OK?How long will 2200mah last?

74batt.PNG (722.6 KB, Down times: 607)

Author: penguin Time: 3/25/2019 16:36
Plz use the recommended battery for better stability. The duration depends on the workload.

Welcome Firefly Open Source Community (https://bbs.t-firefly.com/)