Firefly Open Source Community

Title: I can not connect to board [Print This Page]

Author: nimadibaj Time: 1/24/2024 13:55
Title: I can not connect to board
Hi,

Debug port on AIO-1126-JD4 board is UART, 3.3 Volt.

It is written in Wiki that: Set the baud rate to the 1.5 M !!!

In the attached image, You can see my minicom configs. But I can't communicate with the boar yet !

I can't even connect to the board via LAN (SSH, 192.168.22.33).
I don't know how to find out if it's Debian on my board or something else.

tchip_askquestions

boot.zip

100.73 KB, Down times: 1

Author: nimadibaj Time: 2/10/2024 01:35
With USB-to-TTL with CH340 IC, my problem solved.

Author: UgurYakut Time: 1/22/2025 19:16
did you connected with ssh? and how you learn the ip adress of card,?

Author: emmajon356 Time: 5 day before
Your article was truly stunning, thank you for sharing! Best of luck! Here’s the free Latest test L6M3 cram review test content for everyone.

Welcome Firefly Open Source Community (https://bbs.t-firefly.com/)