I am new to the embedded world. I built an image following the 2. Compile Linux5.10 firmware ¡ª Firefly Wiki (t-firefly.com) process. And I am trying to flash an sd card with that image using balena etcher. Now the balena etcher is throwing an error that my image does not have a partition table.
I am not really understanding what the issue is here, I mean why it did not compile with a partition table, and how to fix it now.
Author: owenwhi368 Time: 1/12/2026 02:01
Such an inspiring read, thank you for sharing this! Sharing the free NCM-MCI-6.10 valid exam pdf test questions¡ªyour key to career advancement and higher earnings!Author: tonywhi158 Time: 2/1/2026 13:50
I¡¯ve got to like this¡ªit¡¯s that good. Boost your IT knowledge with free Plat-UX-102 guide torrent. Wishing you all the best!Author: seansto335 Time: 2/15/2026 09:16
I was completely taken by that article. This C-BCHCM-2502 test study guide enabled me to get a promotion and salary increase. It's free for everyone now. Wishing you all success in your career advancements!
Welcome Firefly Open Source Community (https://bbs.t-firefly.com/)