INSTC_V8勉強の資料 & INSTC_V8復習時間あなたは進歩を遂げたいですか。あなたはどのようにして勉強するのかわかりますか。この時、おそらく私たちのINSTC_V8試験準備資料の助けが必要でしょう。私たちのINSTC_V8試験準備資料を使用している人の99%がすでに望む証明書を持っていました。私たちのINSTC_V8試験準備資料を買う限り、あなたも成功できます! BICSI Installer 2 - Copper Exam 認定 INSTC_V8 試験問題 (Q54-Q59):質問 # 54
Which of the following is a building-serving space that houses large pieces of common active equipment?
A. TR
B. Battery room
C. Mechanical Room
D. ER
E. TE
正解:D
質問 # 55
According to BICSI guidelines, which of the following best describes the maximum pulling tension recommended for a 4-pair UTP cable during installation (without using special pulling grips)?
A. 44 kg (100 lb)
B. 11 kg (25 lb)
C. 66 kg (145 lb)
D. 22 kg (50 lb)
正解:D
質問 # 56
Which type of tester includes a set of modular plugs?
A. Multimeter
B. Tone generator
C. Cable-end locator kit
D. Inductive amplifier
正解:C
質問 # 57
A cross-connect in the Telecommunications Room uses 110-blocks. Which parameter is MOST important to verify after performing cross-connects?
A. The block's brand matches the cable manufacturer
B. Continuity and wire map for each pair
C. A 25 mm (1 in) cable slack behind the block
D. That block label colors match the TIA standard
正解:B
質問 # 58
How long does it take someone to form a first impression?