Juniper JN0-650日本語版試験勉強法 & JN0-650テスト資料多くのIT者がJuniperのJN0-650認定試験を通してIT業界の中で良い就職機会を得たくて、生活水準も向上させたいです。でも多くの人が合格するために大量の時間とエネルギーをかかって、無駄になります。同等の効果は、Xhs1991は君の貴重な時間とお金を節約するだけでなく１００％の合格率を保証いたします。もし弊社の商品が君にとっては何も役割にならなくて全額で返金いたいます。 Juniper Enterprise Routing and Switching, Professional (JNCIP-ENT) 認定 JN0-650 試験問題 (Q57-Q62):質問 # 57
Which two statements are true regarding bidirectional PIM? (Choose two.)
A. Devices store source and group entries.
B. Requires encapsulation for register messages.
C. Devices only store group specific entries.
D. Forwarding paths can be suboptimal.
正解：C、D
質問 # 58
Referring to the outputs shown in the exhibit, which two statements are correct about the IS-IS adjacency? (Choose two.)
A. R1 is configured to participate in Level 2 only.
B. R2 is configured to participate in both Level 1 and Level 2.
C. R1 is configured to participate in both Level 1 and Level 2.
D. R2 is configured to participate in Level 2 only.
正解：A、B
質問 # 59
Which two statements are true regarding Spanning Tree Protocol? (Choose two.)
A. If all switch ports are the same speed, the switch port with the highest port priority becomes the root port.
B. The switch with the lowest bridge priority is elected as the root bridge.
C. If all switch ports are the same speed, the switch port with the lowest port priority becomes the root port.
D. The switch with the highest bridge priority is elected as the root bridge.
正解：B、C
質問 # 60
In Junos, which configuration statement is used to enable IGMP snooping on a switch?
A. set protocols ospf area 0.0.0.0
B. set routing-options multicast
C. set protocols igmp-snooping vlan all
D. set protocols bgp group external
正解：C
質問 # 61
You ate deploying P|M source-specific multicast (SSM) for a new multicast messaging service You have configured the multicast source to use 236.44.123.100 as the multicast address. You are not able to join the PIM SSM multicast teed.
Which two solutions would resolve this problem? (Choose two )
A. Reconfigure the multicast source to use an address in the range of 224.0.0 0 through 224.255.255.255
B. Add the multicast address to the (edit routing-options multicast ssm-map) stanza
C. Add the multicast address to the [edit routing-options multicast ssm-groups] stanza
D. Reconfigure the multicast source to use an address in the range of 232 0.0 0 through 232.255.255.255
