試験Huawei H12-811_V1.0-ENU専門知識 & 一番優秀なH12-811_V1.0-ENU日本語版サンプル | 大人気H12-811_V1.0-ENU資格専門知識現在のネットワークの全盛期で、HuaweiのH12-811_V1.0-ENUの認証試験を準備するのにいろいろな方法があります。Pass4Testが提供した最も依頼できるトレーニングの問題と解答はあなたが気楽にHuaweiのH12-811_V1.0-ENUの認証試験を受かることに助けを差し上げます。Pass4TestにHuaweiのH12-811_V1.0-ENUの試験に関する問題はいくつかの種類がありますから、すべてのIT認証試験の要求を満たすことができます。 Huawei HCIA-Datacom V1.0 認定 H12-811_V1.0-ENU 試験問題 (Q329-Q334):質問 # 329
Routing protocols can detect faults through Hello packets, so BFD is not needed.
A. True
B. False
正解：B
質問 # 330
Regarding the description of the VRRP slave device, which one is correct? (Multiple choice)
A. When the Slave receives the VRRP packet sent by the Master, it can judge whether the status of the Master is normal
B. Slave will discard IP packets whose destination MAC is the virtual MAC address
C. Slave will respond to the IP packet whose destination IP address is the virtual IP address
D. When receiving a VRRP message with a priority of 0, the Slave will directly switch to the Master
正解：A、B、D
質問 # 331
A switch receives a unicast data frame with a VLAN tag, but finds that the destination MAC address of the data frame cannot be found in its MAC address table, then the switch's processing behavior for the data frame is?
A. The switch will discard the data frame
B. The switch will broadcast the data frame to all ports
C. The switch will broadcast the data frame to all ports (except the receiving port) belonging to the VLAN where the data frame is located
D. The switch will broadcast this data frame to all Access ports
正解：C
質問 # 332
In the network shown in the figure, the configuration information of Router A is as follows. Which of the following statements is wrong?
A. The host whose source IP address is 200.0.12.2 cannot access the Internet
B. The host whose source IP address is 200.0.12.6 cannot access the Internet
C. The host whose source IP address is 200.0.12.4 cannot access the Internet
D. The host whose source IP address is 200.0.12.8 cannot access the Internet
正解：D
質問 # 333
When configuring OSPF on a router, what must be manually configured? (Multiple choice)
A. Configure Router ID
B. Create an OSPF area
C. Specify the network type of each OSPF-enabled interface
