NS0-185実際試験、NS0-185合格率進歩を遂げ、NS0-185トレーニング資料の証明書を取得することは、当然のことながら、最新の最も正確な知識を指揮する最も専門的な専門家によるものです。それが、NetApp Storage Installation Engineer, ONTAP Professional Exam試験準備が市場の大部分を占める理由です。それに、NS0-185練習教材の利益を待つのではなく、支払い後すぐにダウンロードできるので、今すぐ成功への旅を始めましょう。 Network Appliance NetApp Storage Installation Engineer, ONTAP Professional Exam 認定 NS0-185 試験問題 (Q18-Q23):質問 # 18
An iSCSI LIF fails to migrate during a storage failover test.
In this scenario, why did the LIF not migrate?
A. The failover policy was not configured
B. LIFs that serve block protocols do not failover
C. LIF failover was not enabled
D. A failover port was not defined
正解：B
解説：
SAN LIFs (iSCSI, FC, NVMe) donot use LIF migration. Instead, host multipathing handles path redundancy. Therefore, iSCSI LIFs do not migrate during storage failover.
質問 # 19
After the installation of a new 2-node cluster, you want to ensure AutoSupport is working as expected.
Which two ways can you trigger a new AutoSupport? (Choose two.)
A. Use the OnCommand Unified Manager GUI.
B. Use the ping command on the mailhost.
C. Use the OnCommand System Manager GUI.
D. Use the system node autosupport invoke -type test command.
正解：C、D
解説：
AutoSupport can be manually triggered using the ONTAP CLI command or via System Manager. Ping tests and Unified Manager do not trigger AutoSupport generation.
質問 # 20
After updating BES-53248 cluster switches, which two commands verify a healthy cluster? (Choose two.)
A. network interface show -vserver Cluster
B. network device-discovery show -protocol cdp
C. network port show -ipspace Cluster
D. network interface show -vserver Cluster -fields auto-revert
正解：A、C
質問 # 21
What are two functions of the four Ethernet switches in the supported configuration shown in the exhibit?
(Choose two.)
A. to provide a direct connection for SnapMirror Synchronous
B. to enable SyncMirror replication
C. to install cross-site cluster management switches
D. to provide connectivity for NVRAM over iWARP
正解：B、D
解説：
The exhibit represents aMetroCluster IPconfiguration, which uses Ethernet switches to provide redundant connectivity between sites. In this architecture, the Ethernet switches are responsible for transportingNVRAM replication traffic using iWARP (RDMA over TCP/IP). This enables synchronous replication of write logs between HA partners across sites.
Additionally, the switches supportSyncMirror replication, which maintains mirrored aggregates across sites to provide continuous data availability in the event of a site failure.
SnapMirror Synchronous and cluster management traffic do not use these switches directly in this configuration. Therefore, the correct answers areC and D.
質問 # 22
A customer wants to replace their ONTAP cluster CN1610 switches with Cisco Nexus 3132Q-V switches.
They want to perform a non-disruptive upgrade.
Referring to the exhibit, which cable will be required to non-disruptively migrate to the new switches?
A. a 40GbE QSFP+ to QSFP+ cable
B. a 100GbE QSFP28+ to 4x25GbE SFP28+ cable
C. a 40GbE QSFP+ to 4x10GbE SFP+ cable
D. a 10GbE SFP+ to SFP+ cable
正解：A
解説：
The CN1610 uses 10GbE SFP+, while the Cisco Nexus 3132Q-V provides 40GbE QSFP+ cluster ports. For non-disruptive migration, the interconnect must operate at 40GbE without breakout. AQSFP+ to QSFP+
40GbE cablesupports this requirement and is validated for cluster interconnect traffic. Breakout cables would change port topology and are not used during NDU migration.
