試験の準備方法-最高の350-601日本語対策問題集試験-100％合格率350-601練習問題集試験の受験者向けの多数の350-601学習質問があることは認められていますが、非常に多くの資料のすべての重要なポイントを自分で要約することは不可能です。しかし、あなたは350-601練習資料のこのウェブサイトをクリックしたので、この問題を解決するために当社が特にここにいるので、それについて全く心配する必要はありません。 350-601の実際の試験がどれほど有用で効果的であるかを理解しているため、長期的な協力を求める多くの常連客がいます。トレーニング資料の輝点について一般的な考えをお伝えできるように、トレーニングの利点を3つ挙げます。 Cisco Implementing Cisco Data Center Core Technologies (350-601 DCCOR) 認定 350-601 試験問題 (Q44-Q49):質問 # 44
Refer to the exhibit An engineer must provision a VXLAN deployment The OSPF has already been configured as the underlay protocol All BGP configurations will be performed using the template method The deployment must meet these requirements
* The local update source for leaf switches must be loopback 1
* The router ID must be the local loopback IP address
* The external BGP connections must use a template name
Drag and drop the configuration snippets from the bottom to complete the configuration 正解：
解説：
質問 # 45
Refer to the exhibit.
An engineer must configure fabric binding on a Cisco MDS 9000 Series Switch to match the output. Which fabric database configuration accomplishes this goal?
A.
B.
C.
D.
正解：D
質問 # 46
Refer to the exhibit. Two data center fabrics use VPC data center interconnect. The system MAC value on SW1 is 00:23:04:ee:be:20. Which value must be set to configure the system MAC address?
A. 00:23:04:ee:be:20 on SW3
B. 00:23:04:ee:be:14 on SW3
C. 00:23:04:ee:be:14 on SW2
D. 46:43:32:e5:92:80 on SW2
正解：B
解説：
A is the only option that ensures the two vpc domains have different system MACs.
質問 # 47
Which event is expected during direct upgrade of Cisco UCS Manager firmware?
A. IPMI polling is interrupted.
B. All users logged in to the UCSM are logged out, and their sessions end.
C. The I/O Module reboots immediately after the firmware is activated.
D. Data traffic is disrupted for a single fabric interconnect setup.
正解：A
質問 # 48
Refer to the exhibit. An engineer must monitor the Ethernet port and the corresponding VLAN traffic for the hyper4 device The SW3 device is a Cisco Nexus 7000 Series Switch Drag and drop the code snippets from the right into the boxes in the configuration to meet these requirements. 正解：
解説：
Explanation:
Graphical user interface Description automatically generated
