Firefly Open Source Community

Title: FireFly RK3288 and Dallas DS18b20 Temperature Sensor [Print This Page]

Author: sghazagh Time: 9/30/2015 18:21
Title: FireFly RK3288 and Dallas DS18b20 Temperature Sensor
Last edited by sghazagh In 9/30/2015 18:26 Editor

Hello all,
I try to connect a Dallas Temperature Sensor DS18B20 to my FireFly RK3288 board but I am not able to read the values of temperature as the device is not working !
The W1 OneWire driver is enabled for kernel and also I have enabled the "W1-Master-GPIO" and "W1-SLAVE-Temp" for kernel but I think I need to modify FireFly device tree as well.

Can anyone please advise and assist me to add to device tree if I use pins shown in attached image to connect my sensor to?

I actually looking for a document showing the GPIO numbering but I couldn't find any document which clearly explain it. Therfore the FireFly GPIOs numbering are not quite clear for me.
Can anyone help and explain first, how can I fix the above issue and second, how should I use FireFly GPIOs?

Many many Thanks

Author: sghazagh Time: 10/5/2015 06:42
Common!!!!!!!!
No body even have tried that before?
Let's find it out guys!!!

Welcome Firefly Open Source Community (https://bbs.t-firefly.com/)