I can not connect to board

nimadibaj

Hi,

Debug port on AIO-1126-JD4 board is UART, 3.3 Volt.

It is written in Wiki that:  Set the baud rate to the 1.5 M !!!

In the attached image, You can see my minicom configs. But I can't communicate with the boar yet !


I can't even connect to the board via LAN  (SSH, 192.168.22.33).
I don't know how to find out if it's Debian on my board or something else.

nimadibaj

With USB-to-TTL with CH340 IC, my problem solved.