Bluetooth problem after programming flash

mkhazraee

Hi,

I'm trying to program the QN9021 (on the small firefly board which only has a QN9021) but after the programming, the device cannot be found as Bluetooth. I used UART programming through QBlue and also SWD programming through Keil, but it occurs in both cases. To find the Bluetooth device I used both android apps and Qtool of Qblue, but the moment I program a board it cannot be found anymore. Using NVDSConfigurator of QBlue I can assign a new Bluetooth name, and it would be saved to flash, but again the device would not be found anymore. I would appreciate any help, I'm new to developing boards with LTE bluetooth.

Thanks in advance

mkhazraee

Nevermind, I found that I have to enable the advertising through the program during run.

dancole754

日常生活の低生産性と低効率にまだ圧倒されていますか？答えが「はい」の場合、PRINCE2-Foundationガイド急流に注意してください。バランスのとれた一流のサービスを提供するため、夢のPRINCE2-Foundation証明書を取得し、希望の職業に就くことができます。当社の製品にはいくつかの主要な機能があり、PRINCE2-Foundationテストの質問に満足していただけると信じています。そして、PRINCE2-Foundation試験問題を一度試してみると、きっと気に入るはずです。

markfor261

擁有IAPP AIGP認證考試證書可以幫助在IT領域找工作的人獲得更好的就業機會，也將會為成功的IT事業做好鋪墊。

scottry488

Liking this content without any hesitation. About to face the VMCE_v12 free vce dumps exam – hoping for good results!

raywest940

Your article was a breath of fresh air, thank you for sharing it. Here’s the HPE7-A01 latest APP simulations test that contributed to my promotion and salary increase. It’s free for everyone today—hope you all achieve your career goals soon!