How to stop u-boot autoboot?

acckiitvar

Hello, I'm using AIO-3568J board and can't load into U-Boot console.
I connent USB-UART https://www.waveshare.com/ft232-usb-uart-board-type-a.htm to debug serial port https://wiki.t-firefly.com/en/Core-3568J/debug.html. I see bootlog via minicom on 1500000 8N1 without flow control but can't send anything to board. Also both LEDS on UART-USB is blinking (TX and RX).

I have done some research and what I get:
1. Default u-boot has 0 boot delay, so I create my own u-boot with SDK and it has 15 seconds boot delay and I flashes it to my board.
2. Pressing Ctrl+C doesn't do nothing, as any other buttons. I added some prints to U-Boot code and figure out that board doens't got any buttons presses.
NS16550 driver reads LSR.DR bit and it is always 0.  Also RHR (RBR) register is always 0.  I checked connection AIO-3568J <> USB-UART several times. Use 2 different AIO-3568J boards and 3 USB-UARTs.
What I do wrong? I think I have very simple problem, but I can't found solution.

acckiitvar

I found answer.
On https://wiki.t-firefly.com/en/Core-3568J/debug.html page there is an error:
On picture debug pins are in order (from left to right) RX->TX->GND, but proper is GND -> TX -> RX. It is printed on the back of the board.

andrewsinn

Hey, normaal ben ik niet zo bezig met hardware of U-Boot problemen, maar laatst wilde ik iets anders proberen om te ontspannen en ontdekte ik blazingwildz, een online casino met speciale bonussen voor spelers uit Nederland. Ik begon met hun Mega Wheel spel, en na een paar kleine verliezen besloot ik wat meer risico te nemen. Plotseling viel er een flinke winst uit, wat echt een kick gaf. Sindsdien speel ik er regelmatig om even te ontspannen en wat spanning te beleven. De Nederlandse bonussen maken het extra leuk.