I can not connect to board

nimadibaj

Hi,

Debug port on AIO-1126-JD4 board is UART, 3.3 Volt.

It is written in Wiki that:  Set the baud rate to the 1.5 M !!!

In the attached image, You can see my minicom configs. But I can't communicate with the boar yet !


I can't even connect to the board via LAN  (SSH, 192.168.22.33).
I don't know how to find out if it's Debian on my board or something else.

nimadibaj

With USB-to-TTL with CH340 IC, my problem solved.

UgurYakut

did you connected with ssh? and how you learn the ip adress of card,?

emmajon356

Your article was truly stunning, thank you for sharing! Best of luck! Here’s the free Latest test L6M3 cram review test content for everyone.