Device does not start in normal mode, need debug console

EugenyB1 · Posted at 7/6/2023 04:12:07

I am starting with this device, and compiled the image for it.
Flahsed the device, and now it does not start in normal mode. It turns LAN1 leds on, then in 3 seconds off, then on again and so on.
Is there any way to have diagnostic console where I can see all the output starting U-boot? And potentially can see where boot fails?
Thanks.

Firefly · Posted at 7/6/2023 09:31:24

Hello, which kind of device or board do you use? And firmware?

EugenyB1 · Posted at 7/6/2023 19:30:02

Last edited by EugenyB1 In 7/6/2023 21:21 Editor

iHC-3308GW, openwrt build (I guess originally from here - https://gitlab.com/TeeFirefly/rk3308-linux).
Edit: it is NOT openwrt! It is buildroot.

Is there any open source openwrt for 3308GW? This one https://dev.t-firefly.com/thread-104203-1-1.html is a firmware, not a source code.

glenlot752 · Posted at 8 hour before

I’m very grateful for your article, it really caught my attention. Examcode materials are free for everyone—good luck! Exam PTOE collection pdf

[General] Device does not start in normal mode, need debug console

【General】 Device does not start in normal mode, need debug console

View forum before