Firefly Open Source Community

Title: I can not connect to board [Print This Page]

Author: nimadibaj Time: 1/24/2024 13:55
Title: I can not connect to board
Hi,

Debug port on AIO-1126-JD4 board is UART, 3.3 Volt.

It is written in Wiki that: Set the baud rate to the 1.5 M !!!

In the attached image, You can see my minicom configs. But I can't communicate with the boar yet !

I can't even connect to the board via LAN (SSH, 192.168.22.33).
I don't know how to find out if it's Debian on my board or something else.

tchip_askquestions

boot.zip

100.73 KB, Down times: 0

Author: nimadibaj Time: 2/10/2024 01:35
With USB-to-TTL with CH340 IC, my problem solved.

Welcome Firefly Open Source Community (https://bbs.t-firefly.com/)