Firefly-RK3399 slarm64 (aarch64 unofficial slackware)

mara · Posted at 7/17/2017 00:21:40

Last edited by mara In 11/14/2020 05:51 Editor

info: http://fail.pp.ua/board/75

first release only flash to MMC

howto:
1. download all http://dl.fail.pp.ua/slackware/firefly-rk3399/legacy/
2. download rkdeveloptool upgrade_tool
3. unpack Linux_Upgrade_Tool_v1.21.zip, upgrade_tool must be at the root of the image
4. place the board in Loader Mode
5. execute script ./flash_mmc.sh

isle · Posted at 7/18/2017 10:36:25

mara · Posted at 7/30/2017 23:25:05

Added acceleration for X.Org
mpv --vo xv plays 1080p, on the CPU load to 35%

mara · Posted at 8/6/2017 22:29:44

info: http://fail.pp.ua/board/75

release flash to SDCARD

1. The bootloader of the system is written to the image
2. mainline u-boot - U-Boot 2017.09-rc1-00110-gfe84c48eeb-dirty (Aug 06 2017 - 15:29:44 +0300)

howto:
1. download all http://dl.fail.pp.ua/slackware/firefly-rk3399/legacy/
2. /dev/mmcblk0 - уour memory card
dd if=slack-current-miniroot_24Jul17-4.4.71-firefly_rk3399-build-20170806.img of=/dev/mmcblk0 bs=1M
dd if=slack-current-xfce_24Jul17-4.4.71-firefly_rk3399-build-20170806.img of=/dev/mmcblk0 bs=1M

F_Developer_X · Posted at 8/11/2017 17:13:59

Good, thanks for sharing

tjCFeng · Posted at 8/20/2017 06:48:08

thanks

mara · Posted at 8/22/2017 00:53:49

Last edited by mara In 8/27/2017 02:32 Editor

0. images from sdcard
1. update kernel 4.4.77
2 To flash a new loader, you need to convert the board into a maskrom
boot from eMMC and clean boot sector: dd=/dev/zero of=/dev/mmcblk1 bs=32767 count=1
flash uboot to mmc:  ./rkdeveloptool db rk3399_loader_v1.08.106.bin
                                 ./rkdeveloptool wl 0x40 idbloader.img
                                 ./rkdeveloptool wl 0x4000 uboot.img
                                 ./rkdeveloptool wl 0x6000 trust.img
3. after flash uboot transfer sd -> mmc, run setup after booting

nadsat · Posted at 8/26/2017 09:34:08

hi, can't find flash_mmc.sh script where is it located?

cheers .

mara · Posted at 8/27/2017 02:22:53

Last edited by mara In 8/27/2017 02:58 Editor

hi nadsat,

flash_mmc.sh is unnecessary, ш corrected the instruction.
for transfer to eMMC you need to run setup or setup.sh after booting from SD
And flash the loader as described above

nadsat · Posted at 8/27/2017 03:20:42

thanks !!!